Zoryra Forum

Haas

Sign in to post

Haas mills, lathes, and controls.

Haas alarm for low gear on a mill that only has a belt Solved A program from another Haas, posted with a high/low gear M-code, alarms on our belt-drive mill at the first t… Zoryra Forum · Lead · 3 replies · 0 views · 7h Haas DWO that is wrong after a vise swap on the rotary Solved Dynamic work offset on a Haas with a rotary was good last month. We swapped the vise on the platter. The firs… Zoryra Forum · Lead · 3 replies · 0 views · 7h Haas coolant spigot that moves when the enclosure door closes Solved The coolant nozzle is aimed at the cut with the door open. With the door closed it sags and cools the holder.… Zoryra Forum · Lead · 3 replies · 0 views · 7h Haas brushless tool changer missing a pocket The carousel is one pocket off after a recovery from an emergency stop during a tool change. The control thin… Zoryra Forum · Lead · 3 replies · 0 views · 7h Haas gearbox knock on a lathe at low rpm only Solved A Haas lathe knocks in the gearbox under about 200 rpm during a facing cut to center. Higher rpm is quiet. Th… Zoryra Forum · Lead · 3 replies · 0 views · 7h Haas CHC setting 130 and a rigid tap recovery Solved On an older Haas control, a rigid tap faults and the recovery leaves the tap in the hole. Setting 130 and the… Zoryra Forum · Lead · 3 replies · 0 views · 7h Haas tool life that expired mid-pallet and jumped to a sister tool Solved A Haas mill is set with a sister tool. When the life count hit, it swapped and the sister was a different len… Zoryra Forum · Lead · 3 replies · 0 views · 7h Haas NGC work offset that does not match the probe Solved On a Haas NGC the probe cycle writes G54 and the first hole is off by about 0.2 mm in Y. The probe calibratio… Zoryra Forum · Lead · 3 replies · 0 views · 7h