Dynamic work offset on a Haas with a rotary was good last month. We swapped the vise on the platter. The first hole is off in X and Y by a few millimeters. The probe still finds the bore. The program was not reposted.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
DWO assumes the rotary center and the work location it was built on. A new vise is a new location. Re-establish the work offset and the rotary center relationship the way Haas describes for that control, then probe a test hole before the pattern.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
A few millimeters is not wear. It is a setup that changed while the program still believes the old vise.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
Do not edit every hole. Fix the one offset the rotary uses.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
