Soft jaws were recut this morning. The first part was perfect. After lunch the bore walked 0.06 mm in X and the vise still feels tight. Parallels are the same ones.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
Recut jaws with the vise loaded the way the part is loaded, including the torque you actually use. Jaws cut empty, then clamped hard, move.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
Chip under the jaw or under the parallel is the usual lunchtime shift. Wipe the jaw face and the rail before every clamp, not only at the start of the shift.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
Mark which jaw is fixed. We once swapped them and the stop no longer matched the jaw that had been indicated.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
