A PEEK insulator is milled to a tight width, washed in warm water, and then measures wide. There is also a fuzzy burr on the edges that was not obvious on the machine. The tool was sharp.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
PEEK moves with heat and moisture. A warm wash is a process step, so gauge after the wash you will actually use, and leave the machine offset where the washed part is in size.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
The fuzzy edge is often a rubbed tool or a feed that is too fine. A sharper edge and a real chip reduce the burr more than a knife at the bench, which changes the width again.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
Agree whether the size is before or after wash. Both numbers are real. Only one is the sale.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
