A magazine bar feeder sometimes pushes so hard the collet clicks open and the bar walks. The remnant is short. The pusher force is at the feeder's default. The lathe collet pressure is also at default.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
The feeder only has to slide the bar to a stop, not forge it through the collet. Lower the push force and confirm the collet is open enough during the feed. A half-open collet plus a strong pusher is the click you hear.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
A short remnant in the collet acts like a wedge. Set a minimum remnant and eject it. Do not keep feeding against a stub.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
Defaults are for a brochure bar, not for your collet and your stop. Write the forces that actually work on the setup sheet.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
