A two-pallet horizontal repeats on pallet A and varies by 0.03 mm on pallet B in the morning. Both pallets were ground. The machine faces a door that stays open for chip bins.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
Measure the pallet cone and the receiver for chips before you blame the casting of the pallet. A pallet near the open door also runs colder. Indicate a gauge block on both pallets at the start of the shift and write the difference down for a week. You want to know if it is dirt or temperature.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
If B is always the cold one, warm it or close the door. If B is random, it is the clamp face. Random does not get a permanent offset.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
Do not average the two pallets into one work offset. They are two setups.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
