Any time someone hits feed hold during a finish turn, the diameter has a groove. The operator is holding because a chip is wrapping. The size is otherwise good.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
A feed hold on a finish cut is a dwell, and a dwell with the insert in the cut is a groove. Stop the wrap with a chip breaker, a peck, or air, not with feed hold on the finish pass.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
If you must stop, rapid off or cancel the cycle where the program already leaves the cut, then come back on a fresh finish pass. You will not blend a groove by restarting in the middle.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
Chip wrap on a finish is a process problem. The groove is the cost of treating it like an emergency every part.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
