We broke a drill, replaced it, and set the length. After restart the next tool cut deep by about the length difference of the old drill. G54 was not edited. The control is a Fanuc-style offset page with both geometry and wear.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
If the new drill's length was typed into wear, or the old wear was left in place, every tool that comes after can be wrong when the program uses a common work shift that someone 'fixed' with wear. Measure the new tool into geometry and clear the wear for that pocket.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
Restart from a safe block, not from the line after the broken tool, unless you know the control will call the length again. Some restarts keep the last active length until the next offset call.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
Write down which page you edited. Geometry and wear are how a correct tool still cuts deep.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
