Laser mount flatness for La Paz, DWG-5132

DWG-5132 rev B is a 6061 laser mount, 5 pieces, for La Paz. The optic seat calls flatness 0.02 mm. The title block general tolerance is ±0.1 mm. I am not sure which one controls the seat. The seat diameter is 20.00 mm.

Flatness 0.02 mm on the seat overrides the ±0.1 mm title block for that face only. The 20.00 mm diameter still follows whatever tolerance is on the diameter itself. Say if 20.00 mm is ±0.05 mm or tighter. Is the seat a glued optic or a clamp?

We skimmed a 6061 seat to 0.02 mm flat and the 20 mm bore, left at the title-block ±0.1 mm, measured 20.08 mm. The optic still seated. The buyer later said they had wanted ±0.02 mm on the bore too, which was not on the print.

I will leave flatness 0.02 mm on the seat and add ±0.05 mm on the 20.00 mm bore so it is written. 5 pieces of 6061. Does that flatness still fit an 8–10 day quote?