DWG-5126 rev A is a 304 cover, 10 pieces, drawing in millimeters, going to Lima. The outside is as-machined. The gasket face is Ra 3.2. Four M5 holes are masked if we anodize, but this is stainless so I think we should not anodize at all.
304 cover for Lima, Ra 3.2, DWG-5126
Do not anodize 304. Leave it as-machined and keep Ra 3.2 on the gasket face only. Masking language copied from an aluminum print will confuse the quote. The M5 holes just need a clean tap. Is the gasket face one side only?
We once blasted a 304 cover because the note said 'finish like the aluminum one.' The face measured Ra 1.1 and the buyer had asked Ra 3.2. The plain milled face on the remake was Ra 2.8 and they took it.
I am deleting the anodize line. Gasket face stays Ra 3.2, one side, M5 tapped, 304, 10 pieces. Please confirm the 8–10 day tier without a coating.