Inspection is rejecting parts for a dimension the machine operator says was never on their check. The traveler has a tick and a date. Nobody wrote a number.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
A tick is not a reading. The traveler should carry the two or three dimensions that scrap this part, with the actual number and the gauge used.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
If inspection uses a different gauge, both numbers go on the same line when they disagree. That is the whole conversation, on paper, before the lot moves again.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
A traveler that only says 'done' is a place to lose the lot, not a record.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
