I watched a part get tapped home with the air gun brass tip because the stop was proud. The operator says it has always been done and the bore still checks.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
If the part needs a hammer to meet the stop, the stop or the jaw is wrong. A tap moves the part and it also moves the stop over time, which is why the bore 'still checks' until the day it does not.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
Stone or recut the stop so the part sits under clamp pressure alone. Then indicate it once and stop tapping.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
Write 'no hammer' on that setup. Habits survive speeches. They do not survive a sheet the next person has to sign.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
