A Fanuc mill with smoothing on rounds an inside corner that the print shows sharp for a matching square tenon. The tool is small enough. The code has a sharp corner. The part has a radius the tenon will not enter.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
Smoothing and corner rounding in the control will ease a sharp programmed corner. For a corner that must stay sharp, turn that smoothing off for those blocks, or the tenon will not fit no matter how small the tool is.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
A sharp inside corner still needs a relief if the mating part is truly sharp. Two sharp corners cannot fill each other. If the print is impossible, say so. If it is possible, the control must be told not to ease it.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
Check the corner with a pin or an optical check before you polish. A rounded corner is the control, and polish will not square it.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
