Tool lengths were set with the auto measure on the table. One tool was set on a parallel by mistake and is short by the parallel thickness. It is the finish mill. The roughing tools are fine. The finish floor is deep by about that thickness.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
Reset that one tool on the same surface as the others. A parallel under one tool is a length error exactly the thickness of the parallel, which matches a deep floor on only the finish tool.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
Then check the floor with a gauge before you adjust wear. If you wear-offset a bad length, the next time someone resets the tool correctly the wear is a second error.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
The measuring face should be one face, labeled, with nothing on it. This is a setup rule because it will otherwise happen to the most expensive tool.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
