A family program reads a variable for length. Yesterday's long part is still in the variable. Today's short part was faced as if it were the long one and the tool went past the face into the soft jaw. The program header says to set the variable. Nobody did.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
A family program starts with the variable on the screen and a forced entry, or it starts wrong. Make the program alarm if the length variable is outside today's range, so yesterday's value cannot silently run.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
Put today's length on the setup sheet in the same units the variable uses. A note that says 'set length' without the number is how the jaw got cut.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
After a crash into the jaw, check the jaw and the variable before the next part. The variable did exactly what it was left holding.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
