A peck drill cycle from an older OSP faults on a newer Okuma at the same line. The depths are reasonable. The cycle format was copied from a program that still runs on the old machine. The newer control is in a different mode.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
Do not assume OSP peck cycles are portable across generations. Check the cycle format the new control wants, and repost or rewrite that one cycle. A fault at the cycle line is format, not a dull drill.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
Prove one hole. Then copy. A hand-fix of the cycle on one hole, multiplied by fifty, will be wrong in the same way fifty times if you misread the format.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
Keep the old program on the old machine. Shared names across two OSP generations are the start of this fault.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
