A probe cycle added at the start of a Mazatrol process writes an offset the process then does not use. The probe result looks right on the offset page and the part is still off by the old work shift. The process uses its own zero.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
A Mazatrol process can carry its own zero that is not the G54 you just wrote. Put the probe result in the zero the process actually reads, or probe inside the process the way that control expects. A correct number in the wrong page is the offset you are seeing.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
Run one approach in single block and watch which zero is active on the screen when the tool moves. Believe the active zero, not the page you edited.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
Document the page for the next person. This exact miss is how the old shift comes back.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
