On a Mazak milling control the finish looks bright except for a tick at each corner of a square pocket. The CAM is posted as EIA. Corner smoothing is on. The tick is small and the buyer sees it.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
A tick at a programmed corner is the control obeying a sharp corner or a smoothing setting that does not cover that move. Look at whether the post output a radius or a sharp point, and at the smoothing level for that mode. EIA on a Mazak still has to be told to round.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
If the print allows a small corner radius, post the radius. A control that is asked to make a sharp corner will hesitate or tick.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
Do not polish four corners on every part and leave the post alone. The tick is in the code or the smoothing page.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
