A Mazak lathe in Mazatrol has tool 3 as a grooving tool in the tool data and a turning tool in the turret. The program header looks right. The first groove attempt was a turn insert trying to plunge. Nobody was hurt. The insert is gone.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
Stop and reconcile tool data to the turret before cycle start. Mazatrol will do what the tool data says the shape is. A turning insert described as a groove tool will plunge. The picture in the control has to match the pocket.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
After a crash or a turret load, the data page is part of the setup, not paperwork. Touch the nose and confirm the type, the width, and the direction.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
Label the holder. A grooving tool and a turning tool in similar holders are how this happens on a Friday.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
