The ballooned report covers every numbered dimension and misses a note that says 'all untoleranced diameters ±0.1' and another that says 'install inserts flush.' The diameters are fine. Two inserts sit proud. The buyer rejected the FAIR.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
Notes are requirements. A FAIR that only balloons the numbered dims is incomplete. Add the insert flush check and any default-tolerance diameters you actually produced.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
Proud inserts are a process check, not a surprise. A flush pin or a finger plus a straightedge belongs in the plan.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
Resubmit the FAIR with the missing lines rather than arguing that notes are not dimensions. The buyer is right that the form skipped them.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
