The floor is still 0.5 mm high. The finish operation is walls only, which the tree makes obvious after the scrap. The roughing leftover was 'finish stock' and nobody owned the floor.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
Every face that has a tolerance needs an operation that cuts it. Stock left for a finish that does not exist is a high part. Add a floor finish or let the roughing cut the floor to size on purpose.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
In the review, hide nothing. A ten-second check of remaining stock in the model shows a high floor before the machine does.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
Template toolpaths are the usual cause. A wall-finish template does not grow a floor pass because you duplicated it.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
