A buyer calls for ten covers today. The vise has a fixture for a different part with twenty pieces left. Pulling the fixture loses the offset and the afternoon. Leaving it misses the hot job.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
If the machine has a second vise or a pallet, the hot job goes there and the current offset stays untouched. If it does not, finish the piece in the vise, record the pin check, and only then pull the fixture.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
Do not zero G54 for the hot job on top of the old one. Use the next offset and write the old numbers down before anyone touches the page.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
A hot job that destroys a proved setup is more late than the hot job was.
Forum posts from Zoryra Forum.
Questions and answers were written on this account when they were published.
